1043830 Miller 60K Downflow FER Gas Furnace 95% AFUE Front Return

MILG2R060F1ACM2 MFG #: 1043830
  • Manufacturer Name: Miller
  • Description
  • Documents
  • Specifications
The high efficiency downflow gas furnace is designed for all manufactured housing applications. It may be installed in a utility room, or enclosed in a closet. CSA design certified for use in the United States and Canada.
  • 100% fired and tested, all units and each component (both mechanical and electrical) are tested on the manufacturing line
  • Clean and quiet operation- Due to the unique design of in-shot burners, location of inducer and use of insulation
  • Fixed 30 second blower delay- At burner start-up assures a warm outlet air temperature at furnace start-up.Adjustable blower off settings (60, 90, 120 and 180 seconds)
  • Fixed 30-second post purge- Increases life of heat exchanger
  • Dependable, hot surface ignitor- Innovative application of silicon nitride type igniter. Utilizes proven Smartlite technology to extend igniter life
  • Tubular primary heat exchanger- Heavy gauge aluminized steel heat exchanger assures a long life
  • Stainless steel secondary heat exchanger- Assures a long life
  • 60 second fixed cooling cycle blower-off delay (TDR)- Increases cooling performance when matched with a Nortek Global HVAC coil
  • Sealed combustion approved for direct vent furnace,category IV venting system- May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation
  • LP convertible- Simple burner orifice (included w/unit)and gas valve regulator change for ease of convertibility
  • 3 amp fuse protection against low voltage shorts- Protects transformer and control board
  • Low voltage terminal board- For easy field wiring
  • Easy open pawl latch- Secures the door firmly for transit, yet allows easy removal for access
  • Appliance quality door- Protects against rust and other corrosion. Baked enamel finish allows for easy cleaning
  • Fully insulated cabinet- Insures minimized heat loss and quiet operation
  • Color coded wire harness- Designed to fit the components, all with quick-connect fittings for ease of service and replacement
  • Multi-speed ECM blower- Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection. 40VA transformer included
  • Diagnostic lights for easy troubleshooting without counting flashes- Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes